The hottest professional brand of Xinjiang 8-inch

2022-08-21
  • Detail

Xinjiang 8-inch LED driving light professional brand

Xinjiang 8-inch LED driving light professional brand

source network release time: 02:31:02

Xinjiang 8-inch LED driving light professional brand

one of the biggest advantages of LED is that it is easy to control. And it can be controlled in clusters. In some occasions that require programmable ability, LED intelligent products can provide a series of solutions, including three primary color LED lamps and intelligent LED lamps with a microprocessor. The configuration can run on Ethernet, which provides convenience for the intelligent management of indoor lighting, and also desalinates the disadvantage of high initial investment cost caused by the use of LED lighting lamps. Research data show that because LED is a cold light source, semiconductor lighting itself has no pollution to the environment. Compared with incandescent lamps and fluorescent lamps, the power saving efficiency can reach more than 90%. Under the same brightness, the power consumption is only 1/10 of that of ordinary incandescent lamps and 1/2 of that of fluorescent tubes. If we replace 50% of our current traditional lighting with LED, the electricity saved in China every year is equivalent to the total power generation of a Three Gorges power station, and its energy-saving benefits are very considerable

in the past 10 years,

the structural design of material waterproof lamps does not need to be too precise, as long as the design reserves a colloid filling area, and the liquid does not leak out, its waterproof performance is very intuitive. Therefore, the material waterproof process is more suitable for small outdoor lamps and indoor moisture-proof lamps. It is usually widely used in low-end and cheap public model products. Such as soft lamp strip, small strip lamp, buried lamp and other small lamps. Whether structural waterproofing or material waterproofing, for the long-term stability and low failure rate of outdoor lamps, a single waterproof design is difficult to achieve high reliability, and the potential hidden danger of water seepage still exists. LED is a kind of green light source. LED lamp is DC driven, without stroboscopic; No infrared and ultraviolet components, no radiation pollution, high color rendering and strong luminous directivity; Good dimming performance, no visual error will occur when the color temperature changes; The calorific value of cold light source is low, which can be safely touched; These are beyond the reach of incandescent lamps and fluorescent lamps. It can not only provide comfortable lighting space, but also meet people's physiological and health needs. It is a healthy light source to protect vision and environmental protection. At present, a single LED has small power and low brightness, so it is not suitable to be used alone. However, it has broad application prospects to design a practical LED lighting lamp by assembling multiple LEDs together

Xinjiang is divided according to the working principle: the simplest voice controlled LED lamp is to add a switching power supply to realize its function, which can only realize the lamp switch; The lamp designer can decide the shape of the lamp optical system, the number of LEDs and the power according to the requirements of the lighting object and luminous flux; Several LED light-emitting tubes can also be combined into a "secondary light source" of point light source, ring light source or area light source, and the lamp can be designed according to the combined "secondary light source". The enclosure protection grade of LED road lamps shall at least reach IPX3, and the enclosure protection grade of tunnel lamps shall at least reach ipx5

led lamp heat dissipation is also very important. For lamps with the same power factor and lamp beads of the same quality, if the heat dissipation conditions are not good, the lamp beads will work at high temperature, the light attenuation will be great, and the lamp life will be reduced. The quality of lamp beads depends on chip quality and packaging technology. The service life of the power supply is much shorter than that of other parts of the lamp. The service life of the power supply affects the overall service life of the lamp. The theoretical service life of the lamp bead is 10000 hours, while the service life of the power supply is 0 Ten thousand hours, the design and material selection of the power supply will determine the service life of the power supply. Light color is the basic element of visual aesthetics and an important means to beautify the room. The selection of light source directly affects the artistic effect of light, and LED shows unparalleled advantages in the artistry of light color display lamps; At present, color LED products have covered the whole visible spectrum range, with good monochromaticity and high color purity. The combination of red, green and yellow LED makes the selection of color and gray scale (16.7 million colors) more flexible. LED technology makes room lamps and lanterns better combine science and art, breaking the edge frame of traditional lamps and lanterns, and surpassing the inherent concept of the so-called lamp form. Lamp design recognizes, understands and expresses the theme of light from a new angle in the artistic creative expression of visual perception and form

led chip damage will directly lead to LED failure, so it is very important to improve the reliability of LED chip. During the evaporation process, sometimes the chip needs to be fixed with a spring clip, so it will produce pinch marks. In yellow light operation, if the development is incomplete and the mask is broken, there will be residual excess metal in the luminous area. The quality reliability of grains in the first stage of the process is 4. Tweezers, flower baskets, vehicles, etc. must be used in various processes such as cleaning, evaporation, yellow light, chemical etching, fusion, grinding, etc., so there will be scratches on the grain electrode. LED lamp refers to the lamp with LED (light emitting diode) as the light source. Because LED has the characteristics of high brightness, rich color, low power consumption and long service life, LED is widely used in the automotive field. Since entering the market, Bonner lamps have gradually been liked by customers for the characterization of metal mechanical properties. Bonner lamps have high reliability, long service life and perfect protection circuits. They have independently developed, designed and manufactured, established their own factories, and constantly found and solved problems in practice. The structure of LED lamps is very simple. Its impact resistance and seismic resistance are very good. There is no need to worry that the bulb will be easily broken, and it can well adapt to various harsh environments. Because the performance parameters of LED light sources have not reached the level of standardization, and many LED light sources used in lamps are irreplaceable, the concept of light efficiency has also been misused in LED lamp products

Copyright © 2011 JIN SHI